No water is coming out of the whirlpool jets on the yacht
When the hydromassage system is turned on but no water flows from the jets, one of the most common issues is the failure of the filtration or hydromassage pump.
This issue may have various causes, ranging from a blockage in the pump to circulation or power supply problems.
How to get water flowing from the hydromassage jets on a yacht
In the section below, we explore the most common reasons why the pump might not activate properly and provide practical solutions to quickly restore the system to full functionality.
Suction pipe
The suction pipe might have a leak at a joint or valve that has loosened due to vibrations, allowing air to enter and preventing the pump from priming. To resolve this, the leak must be identified and sealed.
Ball or butterfly valves
If the valves are loose, they may compromise the proper functioning of the system. It is advisable to tighten them securely using the appropriate tool.
Pump positioning
If the pump is installed at a level higher than the water surface, priming difficulties may occur. For a self-priming pump, the priming process happens automatically after a few minutes. However, for a non-self-priming pump, the process is more complex, requiring manual filling of the pipe before restarting the pump.
If the issue persists despite troubleshooting attempts, please contact our support service. Using our advanced remote control and monitoring tools, we can diagnose the fault and intervene quickly and efficiently, all remotely. This approach allows us to resolve the problem promptly without the need for an on-site visit, ensuring uninterrupted service and optimal system restoration.
